Though like everyone, I'd love the fastest of the bunch to be the default - anything over 300MB/s sustained would've been great, and totally acceptable.īut over the course no more than 10 seconds after resuming, it'd follow this trend. That's just to provide an overview of how massive the range is, despite the file sizes all being large. The highest 2% of transfers peaked out at 1.2 GB/s. The highest 15% of transfers peaked out at 550MB/s. The highest 50% of transfers peaked out at 450MB/s. The slowest 50% of transfers peaked out at 300MB/s. though, only for a few seconds before falling again.

The slowest 20% of transfers peaked out at 225MB/s. I noticed getting even higher peak transfer speeds upon resuming if I waited a little longer after it paused the transfer. Once the transfer completes pausing on Windows, the FreeNAS server again, becomes responsive. Make sure the FreeNAS system is powered on and connected to the network. Often it wouldn't load and would eventually reply:Ĭonnecting to FreeNAS. after noticing the CPU utilization wasn't updating I attempted to reload FreeNAS (reload web page IP address). I CAN ping the IP and get normal-latency for replies.

Pausing the transfer never occurs quickly, and sometimes takes 2+ minutes to completely respond to the pause command.ĭuring this time, especially if the transfer rate slowed to under 1MB or down to 0KB/s even. I experimented with pausing the transfer via Win10 to see what occurred upon resuming: ramping up from 150MB/s and quickly reaching 500-600MB/s.Īfter perhaps 10 seconds however it will start falling until reaching 20KB/s where it'll stay, or as the cycles iterate, will drop to 0KB/s. Transferring data TO the FN server initially starts normally. WD Black: NVMe (easily sustains 2+ GBps).元 Routing + Wireless AP: Airport Extreme.

FreeNAS 11.3 U4.1 - Dell T620 PowerEdge.

600mb file free email sender